Technical article 104900

Adaptec 2940 no longer detected when upgrading to OpenServer 5.0.0.

OpenServer 5.0.0

Written · Last revised

Problem

I am trying to upgrade my system to SCO OpenServer Release 5.0.0,
but my Adaptec 2940 PCI card is not being recognized.  During the
upgrade, I get the error message:
..no root disk controller...

I also notice that this boot message does not appear when booting from the installation floppy:

...%adapter.....type=alad...

Previously, the 2940 worked on the same system when using the Advanced Hardware Supplement (AHS) Release 3.4 Boot Time Loadable Driver (BTLD) with SCO Open Server Release 3.0.

Cause

It is possible that your system does not fully comply to the PCI
specification.  The 2940 (alad) driver in the SCO OpenServer 5.0.0
kernel uses the kernel's PCI driver to check for the presence of
the card, whereas the alad driver in AHS 3.4 does not.

Solution

Although it is not a tested or supported configuration, the alad driver in AHS 3.4 can be used with SCO OpenServer 5.0.0.

To do this, take these steps:

1. Type "defbootstr ahslink=alad" at the boot prompt.

2. Insert the AHS 3.4 BTLD disk when prompted to insert the alad volume.

3. You will then see a prompt similar to:

Table io_init contains (at <NUMBER>) another routine named "aladinit"

Please enter
       which routine (0-38) to replace (`?' to list)
       `a' to add "aladinit" at the end [default]
       `n' to do nothing
or `q' to quit:

4. You should enter the <NUMBER> specified in brackets above at this prompt.

5. Replace the BTLD disk with the boot disk when prompted.

See also

boot(HW)

From the Xinuos technical article database, record 104900. Reproduced with permission. The original is at www.sco.com/ta/104900, which is reachable but blocked from search engines. Xinuos marks this article against a retired product line. That refers to the product’s lifecycle, not to whether the advice still works — plenty of it still applies to running systems.

Next step

Need this fixed rather than explained?

Tell us the release, what the system runs and what it is doing. We will reply by email with what we would do next.

  • You deal with the people who do the work
  • No obligation, and no upgrade required before we will help
  • We tell you plainly if something is not worth doing

Send an enquiry

We reply by email. If a server is down, say so in the first line. You can also write to help@scoexpert.com.