Technical article 105384

Booting off a machine with a primary Mylex host adapter and a secondary Adaptec host adapter.

OpenServer 5.0.0OpenServer 5.0.2

Written · Last revised

Problem

The message "Stp_call_oemtab" occurs during installation causing
the installation to fail.  The machine has a primary Mylex dac 960
host adapter, with an array of disks as a raid configuration,
containing the root hard drive. There is also a secondary Adaptec
host adapter, with a tape or CD-ROM to be used as the installation
device.

Cause

Under normal circumstances (for Open Server Release 3.0 and below)
you can't install and boot successfully in a machine using two host
adapters for installation. The above case is an exception.  For SCO
OpenServer 5.0.0 and 5.0.2, this is no longer a problem.  However,
the boot string must be altered for all pertinent releases.

Solution

Make sure that both adapters are properly installed, grounded, and
properly configured. Make sure there are no address and interrupt
conflicts.  Issue the following command at the prompt during boot
time:

defbootstr link="alad mdac" Stp=alad(num, [bus,] id, lun) Sdsk=mdac(num, [bus,] id, lun)

where:
            num = Controller or Adapter controlling the bus. If it is the
                  first of its type, then num is 0. If it is the second, num is
                  1, and so on.
            bus = SCSI bus number (optional - assumed 0 if omitted)
            id  = Target id of the device on the bus. If it is a root hard
drive,
                  it will most likely be 0, unless it is Micro Channel, which
                  will be a 6.
            lun = Device logical unit number.

From the Xinuos technical article database, record 105384. Reproduced with permission. The original is at www.sco.com/ta/105384, which is reachable but blocked from search engines. Xinuos marks this article against a retired product line. That refers to the product’s lifecycle, not to whether the advice still works — plenty of it still applies to running systems.

Next step

Need this fixed rather than explained?

Tell us the release, what the system runs and what it is doing. We will reply by email with what we would do next.

  • You deal with the people who do the work
  • No obligation, and no upgrade required before we will help
  • We tell you plainly if something is not worth doing

Send an enquiry

We reply by email. If a server is down, say so in the first line. You can also write to help@scoexpert.com.