Problem
When I have the drivers installed to support my Boundless terminals, I can no longer run Serial Manager. The Serial Manager loops endlessly on scanning for serial devices.
Cause
The Serial Manager problem is caused by a section in the file:
/opt/K/SCO/Unix/5.0.4Eb/sa/serial/serialOsaIn this file there is a Tcl script (serialOsa) that parses through
the /dev directory looking at every file in it. There is a
loop-around line 1224 where this takes place. It starts:foreach serial [readdir $INITD] {When Boundless devices are present, an endless loop results whenever the Serial Manager is launched and this script is reached.
Solution
This problem been has fixed in SCO OpenServer 5.0.5 when the minimum required supplements for OpenServer 5.0.5 are installed. These are listed at:
http://www.sco.com/support/toolbox/patch.htmlFor SCO OpenServer 5.0.4, take these steps:
Edit the file:/opt/K/SCO/Unix/5.0.4Eb/sa/serial/serialOsaAdd the following 4 lines after line 1224:
# skip Boundless entries in /etc/conf/init.dif { $serial == "ss0" || $serial == "ssp" } continueif { $serial == "ss1" || $serial == "ss2" } continueif { $serial == "ss3" } continueThis makes the loop skip all Boundless directories in /dev when running mkdev serial or mkdev modem.
NOTE: Boundless Technologies, Inc. was formerly known as SunRiver,
and in some cases may still be referred to as such. See also
ta105823, "Boundless (formerly SunRiver) or MaxSpeed terminal emulation causes X server display problems under OpenServer 5.0.4."