Technical article 105829

Configuring several network cards and relinking once causes errors.

OpenServer 5.0.4

Written · Last revised

Problem

If I configure several network interface cards using the Scoadmin Network Configuration Manager or the netconfig(ADM) utility, and then relink the kernel once (after all the configuration work has been completed), I have problems -- either the relink fails, or there is some kind of failure during subsequent reboot. I have Release Supplement RS504C installed.

Solution

This problem, only observed to occur on systems with RS504C installed, has been fixed in SCO OpenServer 5.0.5.

As a workaround for OpenServer 5.0.4, relink the kernel after completing each configuration for an individual network interface.

From the Xinuos technical article database, record 105829. Reproduced with permission. The original is at www.sco.com/ta/105829, which is reachable but blocked from search engines. Xinuos marks this article against a retired product line. That refers to the product’s lifecycle, not to whether the advice still works — plenty of it still applies to running systems.

Next step

Need this fixed rather than explained?

Tell us the release, what the system runs and what it is doing. We will reply by email with what we would do next.

  • You deal with the people who do the work
  • No obligation, and no upgrade required before we will help
  • We tell you plainly if something is not worth doing

Send an enquiry

We reply by email. If a server is down, say so in the first line. You can also write to help@scoexpert.com.