Problem
I have an onboard Adaptec 39160 controller in my system and can access devices on both channels of the adapter (ha=0 and ha=1). After adding another Adaptec Ultra160 controller (39160 or 29160), I can no longer communicate with devices off of the 2nd channel of the onboard 39160 controller.
Cause
There is a controller ordering problem on some systems where the 2nd channel of the onboard controller will be initialized after the addition of 39160 or 29160 controller(s) so that it will show up as a higher numbered ha. Consider the following scenario where 29160 controllers are added to a system with an onboard 39160 controller:
Channel A (onboard) : ha=0
Channel B (onboard) : ha=1Added a 29160 controller:Channel A (onboard) : ha=0
Channel B (onboard) : ha=2
New 29160 HBA : ha=1Added another 29160 controller:Channel A (onboard) : ha=0
Channel B (onboard) : ha=3
1st 29160 : ha=1
New 29160 HBA : ha=2 Solution
This has been reported to SCO Engineering.
There are 2 possible workarounds to this problem:
1. You can configure the devices on the second channel per the ordering above and they should function normally.
2. If the onboard 39160 controller is not being used for your root hard drive, you can disable the Adaptec BIOS for that controller which has been noted to make the ordering problem disappear.
See also
TA # 111802 TA # 118965 - Openserver 5 - Devices off the 2nd channel of an Adaptec 3916 controller (ad160 driver) are inaccessible.