Technical article 105765

Error when using the DAC960 utilities: "did not find any DAC960 adapters".

OpenServer 5.0.4

Written · Last revised

Problem

I have installed SCO OpenServer Release 5.0.4 with no problem. I have a Mylex DAC960, and I am using SCO'S driver for that controller. When I try to use any of the DAC960 utilities, I get an error message similar to the following:

DAC 960 MON: Monitor did not see any DAC960 adapters in this system

Solution

The correct device nodes are missing from the install. Please create the following device nodes using ln(C).

ln /dev/mdac/0  /dev/rda100
ln /dev/mdac/0  /dev/rda00
ln /dev/mdac/1  /dev/rda200
ln /dev/mdac/2  /dev/rda300
ln /dev/mdac/3  /dev/rda400

See also

man (ADM) dac960mon, dac960sh, dac960tk

From the Xinuos technical article database, record 105765. Reproduced with permission. The original is at www.sco.com/ta/105765, which is reachable but blocked from search engines. Xinuos marks this article against a retired product line. That refers to the product’s lifecycle, not to whether the advice still works — plenty of it still applies to running systems.

Next step

Need this fixed rather than explained?

Tell us the release, what the system runs and what it is doing. We will reply by email with what we would do next.

  • You deal with the people who do the work
  • No obligation, and no upgrade required before we will help
  • We tell you plainly if something is not worth doing

Send an enquiry

We reply by email. If a server is down, say so in the first line. You can also write to help@scoexpert.com.