Technical article 103775

Get warning message when quitting divvy utility under Version 4.0.

OpenServer 5.0.0OpenServer 5.0.2OpenServer 5.0.4OpenServer 5.0.5

Written · Last revised

Problem

Every time I quit the divvy utility in Version 4.0 of SCO UNIX System, I get the following warning message:

*** WARNING: the root filesystem size of __ 1K blocks
             causes it to extend beyond 1024 cylinders by __ 1K
             blocks, which may be unbootable.
i[nstall]   Install the division set-up as shown
r[eturn]    Return to the previous menu

Cause

A disk division table (divvy table) exists with a root filesystem
that extends beyond 1024 cylinders.  The system may become
unbootable if the kernel is relinked and /unix extends beyond
1024 cylinders.

NOTE: This same warning may occur on SCO OpenServer 5 systems. However, because most OpenServer 5 systems have a separate, small, boot filesystem, the 1024-cylinder limit is not likely to be a problem. You should verify whether this is the case on your OpenServer 5 system before taking action based on the SOLUTION below.

Solution

As long as the divvy root filesystem extends beyond 1024 cylinders the warning message directly above will be displayed every time the user quits the "divvy" utility.

Solution #1

Leave the filesystems "as is." The user should make a boot floppy and a root floppy since the possibility exists that after relinking the kernel, the system may not be able to boot from the hard disk. Note: This is not a recommended solution, just a precaution.

Solution #2

This solution involves changing the disk division table to change the size of the root filesystem so it does not extend beyond 1024 cylinders.

See ta103776, "How do I completely back up, change my disk setup,
and restore?".  This procedure should be used with caution.  If
your backup is made incorrectly, there is a potential for loss of
data.
Solution #3
Assuming that the hard drive controller supports greater than 1024
cylinders, one way to avoid the above problem is provided by some
hard drive controllers.  These controllers provide a functionality
which allows the user to low-level format the hard drive in such a
way that the hard drive appears to the operating system to have
less than 1024 cylinders.  This functionality is referred to by a
variety of names, the most common of which are cylinder translation
and sector translation.  These translation modes allow the operating
system to access the drive using less than 1024 cylinders.  See
ta106469, "My hard drive has more than 1024 cylinders."
For instructions on how to back up and restore your data, see
ta103776, "How do I completely back up, change my disk setup,
and restore?"  You will not have to perform the steps "changing
the disk setup," only those steps having to do with the backup
and restoring of your data.

See also

SCO UNIX System V/386 Release 3.2 Version 4.0 Installation Guide.

ta106469, "My hard drive has more than 1024 cylinders."

ta103776, "How do I completely back up, change my disk setup, and restore?"

From the Xinuos technical article database, record 103775. Reproduced with permission. The original is at www.sco.com/ta/103775, which is reachable but blocked from search engines. Xinuos marks this article against a retired product line. That refers to the product’s lifecycle, not to whether the advice still works — plenty of it still applies to running systems.

Next step

Need this fixed rather than explained?

Tell us the release, what the system runs and what it is doing. We will reply by email with what we would do next.

  • You deal with the people who do the work
  • No obligation, and no upgrade required before we will help
  • We tell you plainly if something is not worth doing

Send an enquiry

We reply by email. If a server is down, say so in the first line. You can also write to help@scoexpert.com.