Technical article 105095

How can I fresh-install upgrade my OpenServer 5.0.0 system to OpenServer 5.0.2?

OpenServer 5.0.0OpenServer 5.0.2

Written · Last revised

Problem

I have read the announcement for SCO OpenServer Release 5.0.2. It says that I can do a fresh-install upgrade of my SCO OpenServer 5.0.0 system if I purchase the SCO OpenServer CD-ROM Media Kit or if I receive the OpenServer 5.0.2 CD-ROM as a component of the SES Quarterly Supplement 0.4.

However, I have only received a CD-ROM.  How can I perform a
 fresh-install OpenServer 5.0.2 if I do not have a Boot disk?

Solution

You need to create the Boot disk and any other disk images that you may need. Depending on your requirements, you may need as many as 5 blank 3.5" floppy disks to make these disk images. The images included on the CD-ROM are:

SCO OpenServer Boot Disk Boot Time Loadable Driver Disk from AHS 5.2 SCO OpenServer IPX/SPX DOS Component SCO OpenServer SCO Gateway for NetWare (2 disks)

To create these images, mount the CD-ROM on your existing SCO OpenServer 5.0.0 system as follows:

mount -r /dev/cd0 /mnt

To make a copy of the SCO OpenServer Boot Disk, place a floppy disk into the 3.5" floppy drive and enter the command:

dd if=/mnt/images/boot/N00 of=/dev/rfd0

To make a copy of the SCO OpenServer Advanced Hardware Supplement Release 5.2 Boot-Time Loadable Driver disk, place a floppy disk into the 3.5" floppy drive and enter the command:

dd if=/mnt/images/ahsbtld/01 of=/dev/rfd0

To make a copy of the SCO OpenServer IPX/SPX DOS Component disk, place a floppy disk into the 3.5" floppy drive and enter the command:

dd if=/mnt/images/ipxspx/01 of=/dev/rfd0

To make a copy of the SCO OpenServer SCO Gateway for NetWare disks, place a floppy disk into the 3.5" floppy drive and enter the command:

dd if=/mnt/images/nuc/01 of=/dev/rfd0

Once the copy is complete, remove the copied disk and place a second floppy disk into the 3.5" floppy drive and enter the command:

dd if=/mnt/images/nuc/02 of=/dev/rfd0
NOTE:     Remember to unmount the CD-ROM when you have finished making the
          disk images. To do this, enter the command:
umount /mnt

From the Xinuos technical article database, record 105095. Reproduced with permission. The original is at www.sco.com/ta/105095, which is reachable but blocked from search engines. Xinuos marks this article against a retired product line. That refers to the product’s lifecycle, not to whether the advice still works — plenty of it still applies to running systems.

Next step

Need this fixed rather than explained?

Tell us the release, what the system runs and what it is doing. We will reply by email with what we would do next.

  • You deal with the people who do the work
  • No obligation, and no upgrade required before we will help
  • We tell you plainly if something is not worth doing

Send an enquiry

We reply by email. If a server is down, say so in the first line. You can also write to help@scoexpert.com.