Technical article 107601

How can I set ipforwarding and ipsendredirects from the command line?

OpenServer 5.0.0OpenServer 5.0.2OpenServer 5.0.4OpenServer 5.0.5OpenServer 5.0.6

Written · Last revised

Problem

I know that I can use netconfig(ADM) to configure my system
as a gateway.  How do I do this from the command line in SCO
OpenServer 5?

Solution

You can use the inconfig(ADMN) command to set the ipforwarding
and ipsendredirects TCP/IP parameters.  Setting both of these
parameters to 1, and restarting TCP/IP, will have the same
effect as enabling your system as a gateway in netconfig(ADM).

To set your system up as a gateway, take your system into System Maintenance mode and issue the commands:

inconfig ipforwarding 1
inconfig ipsendredirects 1

Take the system multiuser to enable the system as a gateway.

From the Xinuos technical article database, record 107601. Reproduced with permission. The original is at www.sco.com/ta/107601, which is reachable but blocked from search engines.

Next step

Need this fixed rather than explained?

Tell us the release, what the system runs and what it is doing. We will reply by email with what we would do next.

  • You deal with the people who do the work
  • No obligation, and no upgrade required before we will help
  • We tell you plainly if something is not worth doing

Send an enquiry

We reply by email. If a server is down, say so in the first line. You can also write to help@scoexpert.com.