Technical article 104777

How to configure a RAID 10 and/or RAID 53 virtual disk array

OpenServer 5.0.0

Written · Last revised

Problem

When I enter the Virtual Disk Manager (VDM) and try to configure a RAID 10 or RAID 53 virtual disk, I get this error message:

There is not enough free space available on the system to complete this configuration, it is all being used for divisions and/or vdisk pieces.

I am returned to the disk setup/administration screen.

Cause

The message means there are no disk pieces available for
configuration in a RAID 10 or RAID 53 virtual disk.  RAID
levels 10 and 53 are derived RAID levels, meaning they
are more complex configurations of other existing RAID
levels.

For more detailed information on RAID levels and terminology, see another article in this database entitled "General information about RAID and the Virtual Disk Manager."

RAID 10 is a virtual disk consisting of striped mirrors
(RAID 1 + RAID 0), which are usually duplexed (the disks
are using separate buses for I/O).  The minimum number of
pieces in a RAID 10 array is four -- which consists of two
two-disk mirrors striped together into one virtual disk.

RAID 53 is a virtual disk consisting of striped arrays (RAID 5 or 4, then striped) which may or may not be duplexed. The minimum number of pieces in a RAID 53 array is six, consisting of two three-disk RAID 5 (or RAID 4) arrays striped together into one virtual disk.

These configurations will protect disks from:
o  Failure of one of the host adapters;
o  Multiple disk failures on a single bus;
o  Multiple disk failures on any bus (unless the failures
   are all in one RAID 5 array).

Solution

To set up a RAID 10 array:

(1) Configure two or more mirrored virtual disks using the
    Virtual Disk Manager, making sure to restore parity for
    each disk before proceeding to step 2.  (Filesystems can be
    created later, but parity should be restored during disk
    configuration.)

(2) Select "Disk==>New" and choose Vdisk type RAID 10.

(3) Continue into the RAID 10 allocation menu and use the
    virtual disks defined in step 1 for the pieces of this
    new RAID 10 disk.

(4) Create a filesystem, if desired, and use the Filesystem Manager to configure the mount options.

Your RAID 10 virtual disk is now online and ready for use.

To set up a RAID 53 array:

(1) Configure two or more RAID 5 virtual disks using the
    Virtual Disk Manager. Make sure to restore parity for
    each disk before proceeding to step 2.  (Filesystems
    can be created later, but parity should be restored
    during disk configuration.)

(2) Select "Disk==>New" and choose Vdisk type RAID 53.

(3) Continue into the RAID 53 allocation menu and use the
    virtual disks defined in step 1 for the pieces of this
    new RAID 53 disk.

(4) Create a filesystem, if desired, and use the Filesystem Manager to configure the mount options.

Your RAID 53 virtual disk is now online and ready for use.

From the Xinuos technical article database, record 104777. Reproduced with permission. The original is at www.sco.com/ta/104777, which is reachable but blocked from search engines.

Next step

Need this fixed rather than explained?

Tell us the release, what the system runs and what it is doing. We will reply by email with what we would do next.

  • You deal with the people who do the work
  • No obligation, and no upgrade required before we will help
  • We tell you plainly if something is not worth doing

Send an enquiry

We reply by email. If a server is down, say so in the first line. You can also write to help@scoexpert.com.