Technical article 109325

How to keep ARCserve from starting when SCO OpenServer 5.0.x is booted.

OpenServer 5.0.0OpenServer 5.0.2OpenServer 5.0.4

Written · Last revised

Problem

I want to configure ARCserve so that it does not start every time I boot SCO OpenServer Release 5.0.x.

Cause

By default ARCserve will start during a system boot.

Solution

The script that starts ARCserve is:
# /etc/rc2.d/S90ARCserve

To keep ARCserve from starting you can use any of the following solutions:

Solution 1:

Move the S90ARCserve file to a different location.

Example: Create a subdirectory in /etc/rc2.d and then move the S90ARCserve file into the new directory:

# cd /etc/rc2.d <Enter>
# mkdir original <Enter>
# mv S90ARCserve original <Enter>

This method will preserve the original filename.

Solution 2:

Edit the S90ARCserve file and add an "exit 0" at the beginning of the file.

Example: Use vi or your favorite editor to open the S90ARCserve
file.  At the top of the file, on its own line enter:
exit 0
Then save and exit the file.

This method will preserve the original filename and file location. However, you will need to remove the "exit 0" statement before ARCserve will start by default again during the boot process.

Solution 3:

Rename the file from "S90ARCserve" to either "s90ARCserve" or "_S90ARCserve".

Example:
# cd /etc/rc2.d
# mv S90ARCserve s90ARCserve
Example:
# cd /etc/rc2.d
# mv S90ARCserve _S90ARCserve

Changing the "S" to an "s" in the filename will keep the script from being started during the boot process.

This method will preserve the file location but the name will need to be changed back to S90ARCserve before it will start by default again during the boot process.

NOTES:    ARCserve can always be stopped or started after the boot process,
          whether or not the S90ARCserve script has been run.
To start ARCserve:
# astart
To stop ARCserve:
# astop

To re-enable ARCserve so that it does start during the boot process, reverse the steps in the solution you chose.

While ARCserve is running the tape device will not be accessible
by normal tape operations (such as tar, cpio, and so on).  ARCserve
will need to be stopped or configured to allow the tape device to be
used by these other tape operations.  See ta100073 for instructions
on this topic.

See also

ta100114, "ARCserve/Open can't contact the tape devices on the system."

ta100073, "Tape drives are busy and unusable after installing ARCserve/Open."

From the Xinuos technical article database, record 109325. Reproduced with permission. The original is at www.sco.com/ta/109325, which is reachable but blocked from search engines. Xinuos marks this article against a retired product line. That refers to the product’s lifecycle, not to whether the advice still works — plenty of it still applies to running systems.

Next step

Need this fixed rather than explained?

Tell us the release, what the system runs and what it is doing. We will reply by email with what we would do next.

  • You deal with the people who do the work
  • No obligation, and no upgrade required before we will help
  • We tell you plainly if something is not worth doing

Send an enquiry

We reply by email. If a server is down, say so in the first line. You can also write to help@scoexpert.com.