Technical article 110791

I am unable to install an ISA Digi XE model board in a system with a PCI Adaptec controller.

OpenServer 5.0.4UnixWare 7.0.0UnixWare 7.0.1UnixWare 7.1.0

Written · Last revised

Problem

I am unable to add an ISA Digi XE board to a system with an Adaptec
PCI SCSI adapter or adapter chipset.  The associated error messages
or conditions may vary.  One symptom of this may be the following
message being displayed on system bootup:

Warning: no memory for Digi board. Check switches. All switches are down for port 320. No memory at 000D0000

Cause

The Digi board requires shared memory, and attempts to allocate it in the range being used by the Adaptec SCSI Select utility.

Solution

This problem is not affected by the dip switch settings of the board. Instead, the mpi software may be used to change the shared memory address for the Digi board. From the UNIX prompt, in single-user mode, issue the command:

# mpi
This will bring up the Digi configuration menu.  Choose the tab for
Configuration.  Select the XE board.  Choose Shared Memory Address,
and select a different address, such as 000E0000.  Press <F5> key
to save change and rebuild the UNIX kernel.
If none of the other shared memory addresses works for the board,
then it may be necessary to allocate shared memory in the system
BIOS.  Instructions for this will vary with different manufacturers
of motherboards.  Consult your motherboard manual for more
information.
If working with the Digi configuration and system BIOS does not
help with the situation, then it may be necessary to purchase a
newer PCI multiport board.  Newer boards from Digi, like the XR
model, do not exhibit this problem.
NOTE:     This problem has been reported to Digi Engineering.

From the Xinuos technical article database, record 110791. Reproduced with permission. The original is at www.sco.com/ta/110791, which is reachable but blocked from search engines. Xinuos marks this article against a retired product line. That refers to the product’s lifecycle, not to whether the advice still works — plenty of it still applies to running systems.

Next step

Need this fixed rather than explained?

Tell us the release, what the system runs and what it is doing. We will reply by email with what we would do next.

  • You deal with the people who do the work
  • No obligation, and no upgrade required before we will help
  • We tell you plainly if something is not worth doing

Send an enquiry

We reply by email. If a server is down, say so in the first line. You can also write to help@scoexpert.com.