Technical article 105621

I cannot get a second CPU to work on my IBM 520 MCA/PCI system.

OpenServer 5.0.0OpenServer 5.0.2

Written · Last revised

Problem

The IBM model 520 (MCA/PCI) is listed in an SCO Technical Article as unsupported with a second CPU. (See TA101956, "HWGUIDE: Support status of IBM machines under SCO XENIX, UNIX, ODT and OSE".) After installing SCO OpenServer Enterprise or Host 5.0.0 or 5.0.2, and then installing and licensing SMP to activate the second CPU on an IBM model 520 (MCA/PCI), the system actually runs slower than with a single CPU.

- or -
If mpsar is run it will show that CPU idle time is about 50%
on a system with no activity; cpusar sar on the second CPU will
show about 50% idle time, while it shows 100% idle time on the
first CPU.  It should be expected on an idle system the cpusar
or mpsar would show CPU idle time between 96% and 100%.
- or -

The system may hang during boot if the second CPU is active.

Cause

The IBM model 520 MCA/PCI system has an APIC that is not supported by SCO Symmetrical Multiprocessing Support (SMP).

Solution

Although the IBM model 520 MCA/PCI system has not been tested and confirmed to work with SCO Symmetrical Multiprocessing Support, it has been reported that the following steps may allow installation and use of a second CPU and SCO Symmetrical Multiprocessing Support (SMP) on an IBM model 520 MCA/PCI:

1. After completing installation of SCO OpenServer 5.0.0 or 5.0.2, reboot. Run the following to make a copy of the "single" CPU kernel:

# btmnt -w
# cp /stand/unix /stand/unix.single
# btmnt -r

2. Obtain Support Level Supplement (SLS) OSS449E and SCO's Advanced Hardware Supplement (AHS) 5.2.

3. While the system is booted to single-user or Maintenance mode, install the products listed below (without rebooting) in the following order:

SCO Symmetrical Multiprocessing Support (SMP)

(Note: An SCO Symmetrical Multiprocessing Support (SMP) license is required to complete SMP installation.)

- then -
SCO Support Level Supplement (SLS) OSS449E
- then -
SCO Advanced Hardware Supplement (AHS) Release 5.2.0
4. Reboot the system.

NOTE: Boot with the single-processor kernel (unix.single) to correct any problems.

NOTE:     Although this article describes steps that may allow installation
          and use of Symmetrical Multiprocessing Support (SMP) on an IBM
          model 520 MCA/PCI, SCO Support does not support this system in
          multiple CPU configuration.

See also

sar(ADM)

TA101956, "HWGUIDE: Support status of IBM machines under SCO XENIX, UNIX, ODT and OSE".

From the Xinuos technical article database, record 105621. Reproduced with permission. The original is at www.sco.com/ta/105621, which is reachable but blocked from search engines. Xinuos marks this article against a retired product line. That refers to the product’s lifecycle, not to whether the advice still works — plenty of it still applies to running systems.

Next step

Need this fixed rather than explained?

Tell us the release, what the system runs and what it is doing. We will reply by email with what we would do next.

  • You deal with the people who do the work
  • No obligation, and no upgrade required before we will help
  • We tell you plainly if something is not worth doing

Send an enquiry

We reply by email. If a server is down, say so in the first line. You can also write to help@scoexpert.com.