Problem
I am trying to transfer information from an SCO Open Server 3.0
system to an SCO OpenServer 5.0 system using magnetic tape. I
make the backup using tar or cpio on the source system, but I
cannot read the tape on the destination system. I have the same
problem when I try to transfer information from an SCO OpenServer
5.0 system to an SCO Open Server 3.0 system. Cause
DAT tapes using the DDS II format seem to be very sensitive to the blocksize being used by the SCSI driver. If the blocksize is different on the target system than that being used on the source system, the tape cannot be read.
Solution
Set the SCSI driver blocksize to be the same on both target and
source systems. This can be done with the setblk option to the
tape(C) command. The blocksize can be set to variable mode using
the command:# tape -a 0 setblkThis has not worked in all cases. A better option is to set the
blocksize to a specific value. For example, set the blocksize
to 1024 bytes with:# tape -a 1024 setblkThis command should be issued on the source system before making the backup, and on the target system before attempting to restore.
The tape command is not supplied as standard with the Open Server
Release 3.0 operating system. It is contained within Support
Level Supplement (SLS) UOD376C, which is available for downloading
from the SLS directory at ftp.sco.com. See also
TA104421, "UOD376C Enhanced SCSI Tape Drivers support variable block tape drives".