Problem
SCO OpenServer installs without a problem on the server, but the operating system then fails to boot. Errors similar to the following come up on the screen:
Not a directory Boot not found Cannot open Stage one boot failure Error loading hd(40) /boot
The system never comes up to a boot prompt.
Cause
The BIOS is having a problem locating the boot file, possibly due to large cylinder count or bad geometry stamped on the disk.
Solution
To make sure that the correct disk geometry is used to install the system, follow these steps:
1. In the system CMOS, disable all DOS features (for example, bios-shadowing) and any caching.
2. At the Boot: prompt, enter the correct geometry for the hard drive, as in this example from an actual install with a 4GB IDE drive:
Boot: biosgeom=(8930, 15, 63)3. Use the "interactive fdisk/divvy" method to install the operating
system. Confirm the reported disk statistics and correct them
if necessary. In the above example, the number of cylinders was
found to be off by one, and changing it from 8931 to 8930
enabled a successful installation.