Problem
When installing Merge 5 on SCO OpenServer 5, I get the following kernel relink errors:
The UNIX Operating System will now be rebuilt.
This will take a few minutes. Please wait.Root for this system build is /
undefined symbol
first referenced in file
mdi_EndOfContigSegment /var/opt/K/SCO/link/1.1.1Ga/etc/conf/pack.d/
vnetint/Driver.o
i386ld fatal: Symbol referencing errors. No output written to unix
ERROR: Can not link-edit unixidbuild: idmkunix had errors.
System build failed. Cause
During the installation of SCO OpenServer 5, network configuration was deferred.
Solution
To work around this problem, take the following steps:
(1) Using the Software Manager, uninstall Merge 5. Highlight the SCO Merge 5 product and open the Software Manager.
Highlight the SCO Merge 5 product from the list.
NOTE: Make sure that no other product is highlighted in the Software Manager before clicking the Remove button.
Click on the Software menu and then on the Remove Software submenu. Then click on Remove.
(2) Relink the kernel and reboot the system.
(3) Install and configure the network card in the OpenServer 5 operating system using a valid IP address with the Network Configuration Manager. When the configuration is complete, relink the kernel and reboot the system.
To verify that networking is working correctly, use the "ping" command from the command line:
#ping www.sco.com(4) Install SCO Merge 5 using the Software Manager. To do this, open the Software Manager. Next, click on the Software menu and then on the Install New submenu.
Choose the host machine and then the Media Device. Next, choose the SCO Merge 5 product from the list and click on the Install button.
(5) Relink the kernel and reboot the system.
See also
netconfig(ADM)