Technical article 110374

I get the message "K_trap - unexpected alignment fault in system mode" or a panic lock timeout occurs.

OpenServer 5.0.0OpenServer 5.0.2OpenServer 5.0.4OpenServer 5.0.5

Written · Last revised

Problem

When configuring a Digi async multiport board, a panic lock timeout occurs, or this message is seen scrolling on the console:

NOTICE: K_trap - unexpected alignment fault in system mode

Cause

This type of panic trap means that the CPU tried to use an incorrectly aligned data address.

Solution

Check SCO's Hardware Compatibility Page to make sure you are using supported hardware:

http://www.sco.com/chwp

Make sure you have installed all required supplements, including those for SMP, if you have a multiprocessor system. A list of minimum required supplements is located at:

http://www.sco.com/support/toolbox/patch.html

If a DPT Raid controller is configured in the system, be sure you have installed the latest firmware update and latest driver for your controller that are available from DPT, to insure optimum sharing of resources with your Digi board.

If you have a Digi multiport board in the system, then the Digi driver may not be correct for that system.

There is a new driver distributed by Digi for use on SCO OpenServer systems. It is available for download from:

http://www.digi.com

You may contact Digi Technical Support for more information.

NOTES: Some systems require Digi's previous driver, also available from Digi's web site. If the system has the most recent driver, and is panicking, then you may need to use the previous revision of Digi's driver for SCO OpenServer. However, be aware that this driver is single-threaded, and some performance degradation could result when this driver is used in an SMP environment.

See also

ta106009, "What are Traps, Interrupts, and Exceptions?"

From the Xinuos technical article database, record 110374. Reproduced with permission. The original is at www.sco.com/ta/110374, which is reachable but blocked from search engines.

Next step

Need this fixed rather than explained?

Tell us the release, what the system runs and what it is doing. We will reply by email with what we would do next.

  • You deal with the people who do the work
  • No obligation, and no upgrade required before we will help
  • We tell you plainly if something is not worth doing

Send an enquiry

We reply by email. If a server is down, say so in the first line. You can also write to help@scoexpert.com.