Technical article 110929

I have installed SMP and rebooted my OpenServer 5.0.x system; now when I go into custom, it hangs.

OpenServer 5.0.5OpenServer 5.0.6

Written · Last revised

Problem

I have installed SCO SMP onto an SCO OpenServer 5.0.5 server after
having first rolled back all patches.  After rebooting, when I go
into "custom" and install new software, it hangs.

Solution

In order to install SMP on a server that already has patches loaded, you must first roll all of the patches back. This is because many of these patches include SMP additions that would not have been loaded if SMP were not installed first.

Having rolled the patches back, boot your server into single-user mode and install the SMP software from the 5.0.5 Installation Media.

Normally, you would then reboot the server back into single-user mode, checking to see that the operating system now sees the new processor(s) in "hwconfig -hc" and then add the additional patches. However, should custom hang at the point of Installing New Software, you will need to remove SMP (which you can still do in custom), reboot, then reapply the SMP software.

Before rebooting the server, load Release Supplement 505A (rs505a). Then allow the kernel to be relinked, and reboot.

You will then be able to go into custom and load the remainder of your patches for SCO OpenServer 5.0.5.

In general, loading SMP even though you have no additional processors installed is fine, as this creates no additional overhead other than increasing the size of the kernel.

You will be notified about unlicensed software on your server, but
this will not affect the performance of your server.  If, in the
future, you need to install additional processors, all you need to
do is license the software as required.

This problem has been seen on Dell 4300 servers and IBM Netfinity servers and has been reported to SCO Engineering.

From the Xinuos technical article database, record 110929. Reproduced with permission. The original is at www.sco.com/ta/110929, which is reachable but blocked from search engines.

Next step

Need this fixed rather than explained?

Tell us the release, what the system runs and what it is doing. We will reply by email with what we would do next.

  • You deal with the people who do the work
  • No obligation, and no upgrade required before we will help
  • We tell you plainly if something is not worth doing

Send an enquiry

We reply by email. If a server is down, say so in the first line. You can also write to help@scoexpert.com.