Technical article 110648

I'm installing SCO OpenServer 5.0.x and get the message "out of scan range."

OpenServer 5.0.0OpenServer 5.0.2OpenServer 5.0.4OpenServer 5.0.5

Written · Last revised

Problem

At the time of Initial System Load (ISL), during the loading of ramdisk image, I get this error message:

out of scan range

Cause

During installation, the agp video cards are not seen.

Solution

Follow these steps:

1. Check the video card to see if it is an agp. If it is, proceed to step 2; if not, go to step 4.

2. Swap it out with one that is not intended to be used for installation.

3. After installing the OS, swap the video cards.

4. Go into the SCOadmin Video Manager and verify if the new video card is auto detected. If not, then select from the list of video adaptors the one that is closest to the model you installed.

See also

ta105662, "What new and enhanced graphics adapter support exists in SCO OpenServer 5.0.4?"

ta105162, "What graphics adapters does SCO AHS Release 5.2.0 support?"

ta105701, "A list of graphics drivers for OpenServer 5.0.0/5.0.2 not available in AHS 5.2.0."

ta105661, "Where can I find new or revised drivers for graphic cards on SCO OpenServer 5?"

From the Xinuos technical article database, record 110648. Reproduced with permission. The original is at www.sco.com/ta/110648, which is reachable but blocked from search engines. Xinuos marks this article against a retired product line. That refers to the product’s lifecycle, not to whether the advice still works — plenty of it still applies to running systems.

Next step

Need this fixed rather than explained?

Tell us the release, what the system runs and what it is doing. We will reply by email with what we would do next.

  • You deal with the people who do the work
  • No obligation, and no upgrade required before we will help
  • We tell you plainly if something is not worth doing

Send an enquiry

We reply by email. If a server is down, say so in the first line. You can also write to help@scoexpert.com.