Technical article 109855

I'm trying to use OpenServer 5 on an IDE disk greater than 8GB, but can only access 8GB.

OpenServer 5.0.4OpenServer 5.0.5

Written · Last revised

Problem

My system contains an IDE disk which has a size of greater than
eight gigabytes (8GB).  Although I can install SCO OpenServer 5.0.4
or 5.0.5 onto it and use the disk, I find that I only have access
to 8GB.

Solution

Currently, the greatest size of hard disk that OpenServer is able to automatically access is 8GB. However, if we can get the correct disk geometry known to the kernel, then it should work successfully.

First, you need to find out the disk geometry of your particular IDE disk. This might be written on the disk, or you might need to run a DOS utility in order to find this out. As an example, one 13Gb IDE disk has the following geometry:

25249 cylinders
16 heads
63 sectors-per-track

The data now needs to be input. There are two methods to achieve this:

1. Install OpenServer 5 as usual until you reach the point where you access the disk. Choose the interactive/divvy installation mode and manually input the cylinder/heads/spt data. Then continue the installation as usual.

2. At the "boot:" prompt of the OpenServer boot disk, use the biosgeom boot parameter to input the geometry information. So, type a line similar to:

defbootstr biosgeom=(25249,16,63)

From the Xinuos technical article database, record 109855. Reproduced with permission. The original is at www.sco.com/ta/109855, which is reachable but blocked from search engines.

Next step

Need this fixed rather than explained?

Tell us the release, what the system runs and what it is doing. We will reply by email with what we would do next.

  • You deal with the people who do the work
  • No obligation, and no upgrade required before we will help
  • We tell you plainly if something is not worth doing

Send an enquiry

We reply by email. If a server is down, say so in the first line. You can also write to help@scoexpert.com.