Problem
During installation of SCO OpenServer 5.0.4 on a Compaq Deskpro 4000, the following error message is received followed by the "Safe to Power Off" message:
Install Source: 10KB/ramFS/extractProd/extractAll
terminated by signal 8 Solution
If the following bootstring parameter is added to the bootstring being used:
Boot: <install bootstring> mem=/pthe memory sizing output shows the following:
Memory found: 0k-638k,638k-640k/p,1m-15m,15m-16250k/s/dModify the installation bootstring as follows:Boot: defbootstr <install bootstring> mem=1m-16mExample: Boot: defbootstr disable=ida mem=1m-16mInstallation should then proceed without error.During the installation process, fdisk will be invoked. SCO
recommends that you use the 5.0.4 fdisk to create the actual
partition that 5.0.4 will be installed into. If the entire disk
is already allocated to existing partitions, use fdisk to delete
unwanted partitions and then select 'Use rest of disk for UNIX'.When running fdisk, SCO also recommends retaining the 'TYPE 18' partition which contains the "ISA Setup and Diagnostics" partition. This can be done by selecting "Interactive FDISK and DIVVY" during the installation and selecting the "Use Rest of Disk" option.