Problem
I have a system that was installed using a Boot Time Loadable
Driver (BTLD). I installed the SCO Advanced Hardware
Supplement (AHS) Release 5.1.0 on my system and, as part of
this process, I replaced the BTLD that I installed with a BTLD
from the SCO AHS. However, when the SCO AHS installation is
complete, and I reboot my system, my root hard disk controller
is not seen by the new kernel created as part of the SCO AHS
5.1 installation. Cause
If a different version of a driver with the same name as an
AHS driver is found during installation, you will be asked if
you want to keep the existing driver or overwrite it with the
new AHS driver. If you answer yes, the 3rd party driver and
its configuration information is overwritten, but the new AHS
driver will not be configured by default into the new kernel.This information is documented on page 47 of the SCO AHS 5.1.0 Release Notes.
Solution
Boot your system at the Boot: prompt and type:
unix.oldThe unix.old kernel is the kernel that was used on your system
before the SCO AHS was installed. Enter single user mode and
type:cd /etc/conf/sdevice.dNow edit the BTLD file that you installed as part of the SCO
AHS. For example, if you are using the NCR BSCAM SCSI Host
Adapter chipset, you would edit this file:/etc/conf/sdevice.d/bhbaThe content of this file will look like this:
bhba N 1 5 0 0 0 0 0 0Use your favorite editor to modify the second field in this file to Y so that it looks like:
bhba Y 1 5 0 0 0 0 0 0Save the file to disk and relink the kernel by typing:
cd /etc/conf/cf.d
./link_unixOnce the kernel has been relinked and you have specified that you want this kernel to boot by default, you should have a kernel capable of recognizing your hard disk controller.