Problem
I've installed the driver, configured the stack, rebuilt the
kernel, and have rebooted the system. The Pro/100 NIC isn't
working. Cause
It's possible that the wrong driver is being used, or the driver's speed is set incorrectly.
Solution
Here are some suggestions for debugging the configuration.
There are several things that can prevent either the eeD or eeE
driver from working correctly. Make sure the correct driver is
installed. The drivers _cannot_ be interchanged.The eeD driver supports the EtherExpress Pro/100, PILA8465 or EILA8265.
The eeE driver supports EtherExpress Pro/100B, PILA8465B.
The driver's default speed is usually 100Mbps. Check that the
configured speed is consistent with the LAN speed. A driver
configured for 100Mbps operation will not operate correctly on
a 10Mbps LAN. Use netconfig(ADM) to examine and configure the
driver. Select the "Advanced Option" button and select either
"Auto" or "10Mbps" for a 10Mbps LAN.Examine the LEDs on the NIC endplate. Is the bottom LED, marked
"100", glowing? Is the top LED, marked "Link", dark? This
combination indicates that the card is configured for 100Mbps
operation and has not been able to establish link at that speed.Alternatively, in the /etc/conf/pack.d/<driver> directory, modify
the space.c file. The directory name will be either "eeD" or
"eeE". In the space.c file there is a variable of the form
EEE_0_MSPEED (for the eeE driver), or EED_0_MSPEED (for the eeD
driver). The variable's value can be set to "0" for "Auto", "10"
for 10 Mbps, or "100" for 100Mbps.Modifying the driver either by using netconfig(ADM) or by editing the space.c file, will require that the kernel be relinked. Relink the kernel and reboot the machine.
See also
TA101579, "Which Intel networking products are supported in the SCO environment?"