Problem
After having added a hard disk entry to my ida controller, the Kernel fails to relink with the following error:
The UNIX Operating System will now be re-built.
This will take a few minutes. Please wait.Root for this system build is /
undefined first referenced
symbol in file
ida_entry conf.o
i386ld fatal: Symbol referencing errors. No output written to unix
ERROR: Can not link-edit unixidbuild: idmkunix had errors.
System build failed. Cause
This may occur if the standard "mkdev hd" command was used to add a hard disk to the ida controller. This is not the correct method, as "mkdev ida" should be used instead.
Solution
Remove the device incorrectly added through "mkdev hd" as follows:
- Log onto the system and as "root" run
# mkdev .scsi- Select option2. Remove a SCSI device- Followed by1. Hard Disk- Enter the same details that were provided to add the device in the first place.
- Once the Kernel has been rebuilt and the system rebooted, add the hard disk via
# mkdev idafollowing the on-screen instructions. See also
The manual pages for ida(HW), mkdev(ADM), link_unix(ADM)TA105052, "How can I remove and reinstall an additional hard disk on SCO OpenServer 5"
TA105864, "How to remove additional hard drive configuration on SCO OpenServer 5.0.4, 5.0.5."