Problem
After installing Release Supplement RS504C on my SCO OpenServer Release 5.0.4 system, relinking and rebooting, my system exhibits one of the following symptoms:
1) the system hangs during the hardware recognition screen after displaying the boot letter "G" (hd_config).
2) tape-related processes, in particular those involving network-based backup management, hang.
My system is a multiprocessor system with two or more CPUs enabled, and I have SCO SMP Release 5.0.4 installed.
Cause
This problem may be caused by a flaw in some RS504C code that deals with distribution and sharing of interrupts in the multiprocessor environment.
Solution
This problem is corrected in the Support Level Supplement (SLS) OSS469D, and also in SCO OpenServer Release 5.0.5. Please
follow the steps below to fix the problem immediately with
OSS469D.1. If you are experiencing the tape-related hangs, skip step 2 below, and immediately proceed with step 3.
2. If you are experiencing the "hang at letter G" scenario,
reboot the machine; you must reset or power cycle the machine
to get to this point. Then enter "unix.old" at the Boot: prompt.NOTE: If you have not experienced the problem yet (that is, if you have installed RS504C but have not yet attempted to reboot) step 2 will avoid the problem, while step 3 below will fix it for subsequent boots from "unix".
3. Install the Support Level Supplement (SLS) OSS469D.
This SLS contains a number of other fixes which may address
other issues on your system. See ta109975 for a detailed
description of the fixes in OSS469D, as well as detailed
installation instructions.4. Finally, reboot the system using the default bootstring, or whatever bootstring is normally employed. This allows the change to take effect.
See also
ta105830, "I cannot install SMP on a system that has Release Supplement RS504C installed".
ta109975, "What is SLS OSS469D, the Core OS Supplement for SCO OpenServer Release 5.0.4?"