Problem
During the installation of SCO OpenServer Release 5.0.x or Internet FastStart 1.0.0, I am unable to configure the integrated network interface card.
Solution
The integrated network interface on a Compaq ProLiant 2500 is a
10/100 TX UTP Controller. The standard network card in a Compaq
ProLiant 5000 is a Netelligent 10/100 TX PCI UTP, which resides
in an expansion slot.The configuration of this interface should be deferred during the initial installation of the operating system.
Immediately after the initial installation, boot up your system and
run /etc/custom or 'scoadmin software'. Install the EFS512 or EFS513
volume 1 diskette. This disk can be generated from your SmartStart
Support CD-ROM provided by Compaq with your ProLiant server.Ensure that you have the NIC connected to the network prior to configuring the interface.
During the installation of the EFS, your integrated NIC will be identified, and you will be prompted as follows:
Add the interface in slot 0 to the cnet driver configuration ? (y/n) y
Do you want to use TCP/IP facilities on the interface in slot 0 ? (y/n) y
Enter the internet address of this interface: 132.147.144.80 Enter the netmask for this interface (default: 255.255.0.0): 255.255.255.0 Does the interface use a broadcast address of all 1's? (y/n) (default: y): y Enter the broadcast address for this interface (default: 132.147.144.255):
Interface Address: 132.147.144.80
Netmask: 255.255.255.0
Broadcast address: 132.147.144.255Are these values correct? (y/n):After the completion of this EFS installation, you will be informed
that the kernel was relinked during the process. Reboot the system
to the new kernel.