Technical article 111122

My OpenServer 5.0.x install hangs on reboot at G diagnostic and "mp_picinit".

OpenServer 5.0.5OpenServer 5.0.6OpenServer 5.0.7

Written · Last revised

Problem

I have installed SCO OpenServer 5.0.x successfully, but when it reboots after the installation, it hangs at the 'G' diagnostic and prints:

mp_picinit

or hangs during the boot process of the initial system load (ISL).

Cause

This may be caused by the network card in the system being too old or conflicting with some other card, at least as the system software sees it. The 'mp' portion of the message is seen on multiprocessor systems.

Solution

The solution is to remove the network card and then reboot. If the system boots up, try un-configuring the card with 'netconfig' and then reconfiguring it. If it still will not reboot, then you will need to replace the network card.

NOTE:     The problem may also be due to another card in the system.
          If  removing the network card does not fix the problem, try removing
          all non-essential cards from the system.
NOTE:     Can also try disabling HyperThreading and USB within the server's
          BIOS or entering at the boot prompt:
defbootstr mp-picinit.disable disable=usb_uhci,usb_ohci,usb_ehci

See also

ta109806, "After installing OSS469B, 'WARNING: CPU2 boot failure' is displayed upon boot-up, or the system hangs at 'E mp_setup', or panics at 'G mp_picinit'."

From the Xinuos technical article database, record 111122. Reproduced with permission. The original is at www.sco.com/ta/111122, which is reachable but blocked from search engines.

Next step

Need this fixed rather than explained?

Tell us the release, what the system runs and what it is doing. We will reply by email with what we would do next.

  • You deal with the people who do the work
  • No obligation, and no upgrade required before we will help
  • We tell you plainly if something is not worth doing

Send an enquiry

We reply by email. If a server is down, say so in the first line. You can also write to help@scoexpert.com.