Technical article 125516

My Openserver 5 system reports "Bad EEPROM read" for the eeE driver when running hwconfig.

OpenServer 5.0.6

Written · Last revised

Problem

I installed OpenServer 5.0.6 on a IBM xSeries 345 system
and configured  the network card. Networking isn't
functional and hwconfig -hc reports a  entry similar to
the one below for the network card:
eeE0               -         -   -   Bad EEPROM read

HARDWARE: IBM xSeries 345 with a Intel Dual Intergrated Gigabit Ethernet

Cause

The wrong driver is trying to initialize the network card.

Solution

Remove the network card from the network configuration manager, relink and reboot. Download and install the gigabit network card driver from:

https://ftp.scoexpert.com/openserver5/drivers/OSR506/network/eeG

Reconfigure the network card, through the network configuration manager. If netconfig detects multiple network cards, make sure you select the PRO1000 network card as opposed to the PRO100 network card.

After relinking and rebooting the network should be functional.

From the Xinuos technical article database, record 125516. Reproduced with permission. The original is at www.sco.com/ta/125516, which is reachable but blocked from search engines.

Next step

Need this fixed rather than explained?

Tell us the release, what the system runs and what it is doing. We will reply by email with what we would do next.

  • You deal with the people who do the work
  • No obligation, and no upgrade required before we will help
  • We tell you plainly if something is not worth doing

Send an enquiry

We reply by email. If a server is down, say so in the first line. You can also write to help@scoexpert.com.