Problem
At the Boot: prompt, I enter "dos" but DOS does not boot.
Solution
Take these steps:1. Test to make sure that DOS is in fact bootable. In the fdisk(ADM)
utility (Unix or DOS fdisk) make DOS the active partition and boot
the computer. (DOS should boot properly.) To enter fdisk through
Unix, boot the system to a Unix prompt and type in:fdisk <Enter>Select "1" to display the partition table, identify the DOS
partition, then select "5" to enter the Partition Activation screen. Now select the DOS partition to make active, following the on-screen
instructions.NOTE: fdisk is to be used with caution as data can be lost during this process.
Once the DOS partition is active, exit fdisk and shut down the
system (shutdown -y -g0), then boot the computer and DOS should
boot normally. If DOS does boot properly, type in:fdisk <Enter>at the DOS prompt (usually c:\) and reset Unix to be the active partition. Exit fdisk and reboot the computer.
2. At Boot: enter "bootos ?". This will display the various partitions found on the hard drive. Note which partition DOS is in.
3. Boot: should return after step 2. Now at Boot: enter:bootos <dos partition number> <Enter>Example: "bootos ?" showed that DOS is in partition 4. At Boot:,
you would enter "bootos 4".4. If DOS boots properly you will want to edit "/etc/default/boot", and add the following line:
dos bootos <dos partition number>5. DOS should now boot properly when "dos" is entered at the Boot: prompt.
See also
manual dos(HW), bootos(HW)