Technical article 105642

My system panics when I try to boot off the boot floppy and root to hard drive.

OpenServer 5.0.0OpenServer 5.0.2OpenServer 5.0.4OpenServer 5.0.5OpenServer 5.0.6

Written · Last revised

Problem

I am trying to boot off of the boot disk of my boot and root floppy
set, and then root to the hard drive. At the boot: prompt I type:
fd(60)unix.Z root=hd(42)

(Note: This is the string to be used when the original installation was a fresh install as opposed to an upgrade, which would use an hd(40) designation.)

And after getting messages about sizing memory and loading the kernel, the system panics with the following message:

PANIC: assertion failed: fp file: ksl.c line:???
where "???" is some number.

Cause

The bootstring is incomplete. You must add ksl.disable to your bootstring which will prevent the streams stack from being built at boot time. Instead, it will be built when entering multiuser mode.

Solution

At the boot: prompt enter the following:

fd(60)unix.Z root=hd(42) ksl.disable swap=hd(41) dump=hd(41)

You will now be able to boot off the floppy and root to the hard drive without the panic occurring.

If you continue to have problems you may require additional entries in your bootstring. If you press <Enter> when booting from your emergency boot disk, you will see the bootstring that is specific to your emergency boot disk configuration. In addition to the ksl.disable, you may see the additional bootstring entries required to enable you to boot and root to the hard drive.

From the Xinuos technical article database, record 105642. Reproduced with permission. The original is at www.sco.com/ta/105642, which is reachable but blocked from search engines.

Next step

Need this fixed rather than explained?

Tell us the release, what the system runs and what it is doing. We will reply by email with what we would do next.

  • You deal with the people who do the work
  • No obligation, and no upgrade required before we will help
  • We tell you plainly if something is not worth doing

Send an enquiry

We reply by email. If a server is down, say so in the first line. You can also write to help@scoexpert.com.