Problem
I am trying to configure the network on my Toshiba Notebook Satellite Pro 4600 / Satellite 2800-500 with OpenServer 5.0.6. On the notebooks, there is a embedded Intel Pro100+ PCI NIC with 2449 chip set (vendor ID 8086-2449). However, the netconfig does not detect the NIC card. How can I configure the NIC through netconfig?
Cause
There is no entry for this particular Intel Pro100 chip set in:
/opt/K/SCO/eeE/rs506a.eeE506.1.0a/ID/eeE/AOF/eeETherefore, netconfig fails to detect the card.
Solution
Follow the steps below to workaround the problem:
The embedded Intel PRO100+ NIC must be configured manually.
1. Choose Intel(R) PRO/100B / PRO/100+ PCI Adapter from the list.
2. It then requests from you the PCI# , Device# and Function#
To find these values, run the command "hw -v | pg" and
page down until you find the section that looks like :-Index: 10
DeviceNum: 8
Function: 0
Bus: 2
VendorId: 0x8086 Intel
DeviceId: 0x2449
RevId: 0x03
Command: 0x0007 Memory Enabled, I/O Enabled
Status: 0x0290
ClassCode: 0x020000 Ethernet controller
CacheLineSize: 8 32 bit words
LatencyTimer: 0x40
HeaderType: 0x00 Single-function, Standard encoding
SelfTest: 0x00 Not BIST capable
BaseAddr[0]: 0xf7dff000 Memory 0xf7dff000, 32 bit space
BaseAddr[1]: 0x0000df41 I/O 0xdf40
.....and so onFrom there, you can see that the PCI#=2, Device#=8 and Function#=0 Enter these values in the netconfig and finish the TCP/IP configuration.
3. Re-link the kernel.On reboot you should see:eeE0 0xdf40-0xdf5f 11 - type=EE PRO/100B 00:00:39:2d:32:3fNOTE: Intel officially does not support this 8086-2449 chip set on OpenServer 5.