Technical article 104945

OpenServer 5 on Pentium P75 systems with power management runs slowly.

OpenServer 5.0.0

Written · Last revised

Problem

SCO OpenServer Release 5 may run incredibly slowly on some systems
based on Pentium P75 based systems.  For example, it might take
thirty minutes to reach a login prompt.
Systems based on identical hardware (motherboard, etc.) with faster
processors (P90 or P100) may run normally.  Changing the clock speed
of the system may also cause the system to run at a more usual speed.

Cause

The power management features of SCO OpenServer 5 do not behave correctly with some motherboard/BIOS implementations of the 'Advanced Power Management' specification.

Solution

Ensure that the BIOS setup disables any power management features. Enter the line in /etc/default/boot:

apm.check=no

This should allow the system to operate correctly.

See also

See apm(HW), uapm(HW), pwr(HW), boot(HW) and the "SCO OpenServer Handbook" for further details on configuring power management.

NOTE:     The Pentium P75 processor is designed for use in 'low power'
          designs; power management features are often disabled at higher
          clock speeds.  However, this problem may occur in systems based on
          other processors.

Always run systems and processors at the speed recommended by the manufacturer.

From the Xinuos technical article database, record 104945. Reproduced with permission. The original is at www.sco.com/ta/104945, which is reachable but blocked from search engines. Xinuos marks this article against a retired product line. That refers to the product’s lifecycle, not to whether the advice still works — plenty of it still applies to running systems.

Next step

Need this fixed rather than explained?

Tell us the release, what the system runs and what it is doing. We will reply by email with what we would do next.

  • You deal with the people who do the work
  • No obligation, and no upgrade required before we will help
  • We tell you plainly if something is not worth doing

Send an enquiry

We reply by email. If a server is down, say so in the first line. You can also write to help@scoexpert.com.