Technical article 110726

Quick check on whether my network interface card (NIC) is working on OpenServer.

OpenServer 5.0.0OpenServer 5.0.2OpenServer 5.0.4OpenServer 5.0.5

Written · Last revised

Problem

I cannot ping other machines on my network but I can ping localhost and my own ip address. What can I do to test my NIC further?

Cause

There are many causes for the inability to ping or communicate on a network. For a more in-depth analysis of NIC problems, see ta107687, "I installed a network interface card (NIC); now I'm having networking problems."

If you are reasonably sure that the cables are correct and if other
machines can ping or communicate fine, then the following set of
tests can help determine if the NIC is working.  Previous to this,
make sure your network driver is the latest version (from either
SCO or your vendor):
For SCO drivers, ftp to:
ftp.sco.com  - anonymous login
cd pub/drivers/OSR50x/network

where OSR50x is your operating system version, for example:

OSR500-502
OSR504
OSR505

Make sure to read the README or .ltr file.

Solution

Check the following:

1. Is the netmask the same as the other machines on the net? (ifconfig -a)

2. Is the NIC set to 100mb/sec in netconfig by mistake when it is on a 10mb network? (May need to change from "auto" to 10mb explicitly.)

3. Try pinging (ping -n bcast_addr) the broadcast address (from ifconfig -a) and see if any machines respond.

4. Do an 'arp -an'; do any entries appear in the table? This indicates it can receive arp info.

5. A 'netstat -in' will show any errors detected in outgoing or
   incoming packets from the broadcast ping.  If the netstat is
   done without the 'n' option (ip numbers) and it takes a long
   time to respond, it may indicate DNS name resolution problems.

6. 'llistat -l' (or ndstat -l) will give more detail about the errors reported in netstat.

If there are errors in transmitting packets then possibly the transmitter or connector of the NIC is defective, and, if the errors show only on receiving packets the receiver section of the NIC may be defective.

If there is no evidence from these tests that the NIC can communicate with other machines on the network, then you may want to consider swapping out the NIC for a different model/brand after unconfiguring it in the network manager.

See also

ta110727, "Quick check on whether my network interface card(NIC) is working on UnixWare 7."

The web page for hardware compatibility:
http://www.sco.com (->support->hardware compatibility)
or:
http://www.sco.com/chwp

From the Xinuos technical article database, record 110726. Reproduced with permission. The original is at www.sco.com/ta/110726, which is reachable but blocked from search engines.

Next step

Need this fixed rather than explained?

Tell us the release, what the system runs and what it is doing. We will reply by email with what we would do next.

  • You deal with the people who do the work
  • No obligation, and no upgrade required before we will help
  • We tell you plainly if something is not worth doing

Send an enquiry

We reply by email. If a server is down, say so in the first line. You can also write to help@scoexpert.com.