Problem
I installed and licensed SCO OpenServer Desktop System Release 5. I then installed and licensed SCO SMP 5 (Symmetrical Multiprocessing Support). When the system boots, it recognizes the extra processor, but when I run mpstat(ADM), cpusar(ADM) or cpuonoff(ADM), only the base processor is shown to be active.
Cause
The SCO OpenServer Desktop system is only for use in single CPU Desktop workstations, and is not intended for use with multi-processor servers.
Solution
To enable your secondary CPUs you must reinstall the system using
an SCO OpenServer Enterprise Release 5 license instead of the Desktop
license. Then install and license SCO SMP 5 as usual. Any additional
CPUs will then be recognized and activated.Contact your SCO software supplier to purchase a trade-in license
going from the SCO OpenServer 5 Desktop license to an SCO OpenServer 5
Enterprise license. If you cannot locate your software supplier,
please call 1-800-726-8649 for a referral for an authorized SCO
reseller.