Technical article 110288

Serial manager fails with "Fatal error: can't read "portInfo": no such variable".

OpenServer 5.0.4

Written · Last revised

Problem

The serial manager fails with the following error:

Fatal error: can't read "portInfo": no such variable

Cause

This can be caused by a comment at the end of the inittab(F) entry for a serial line. For example:

Se1A:2:respawn:/etc/getty -t60 tty1A SM1    # Siteman dial-in line
Se1a:2:off:/etc/getty tty1a SM1    # Siteman dial-in line

Solution

Remove any comment after the last parameter to getty(M) in:

/etc/inittab
/etc/conf/init.d/sio

The above example would therefore be modified as follows:

Se1A:2:respawn:/etc/getty -t60 tty1A SM1
Se1a:2:off:/etc/getty tty1a SM1

See also

The manual pages for inittab(F) and getty(M).

From the Xinuos technical article database, record 110288. Reproduced with permission. The original is at www.sco.com/ta/110288, which is reachable but blocked from search engines. Xinuos marks this article against a retired product line. That refers to the product’s lifecycle, not to whether the advice still works — plenty of it still applies to running systems.

Next step

Need this fixed rather than explained?

Tell us the release, what the system runs and what it is doing. We will reply by email with what we would do next.

  • You deal with the people who do the work
  • No obligation, and no upgrade required before we will help
  • We tell you plainly if something is not worth doing

Send an enquiry

We reply by email. If a server is down, say so in the first line. You can also write to help@scoexpert.com.