Technical article 104958

talk(TC) fails with the error "Couldn't bind to control socket...".

OpenServer 5.0.0

Written · Last revised

Problem

talk(TC) is failing with the error message:

Couldn't bind to control socket : Can't assign requested address (103)

Cause

The IP address that talk(TC) is using for the local system (obtained from /etc/hosts, or a name server) doesn't match the IP address with which the system's network card is configured.

Solution

Check that the system's network card IP address matches that in /etc/hosts or on the name server. To do this, run:

netstat -in
This will generate output similar to:
Name  Mtu   Network     Address         Ipkts    Ierrs Opkts    Oerrs Coll
net0  1500  XXX.XXX.XXX XXX.XXX.XXX.XXX 4773746  0     1821088  0     0
lo0   8232  127         127.0.0.1       31356    0     31356    0     0

where "XXX" will be up to a 3 digit decimal number, specific to your subnet and network card's IP address.

Ensure that the entry for the local system in /etc/hosts, or on your name server, matches that in the "Address" column above.

See also

netstat(TC) talk(TC) hosts(SFF) resolver(SFF)

From the Xinuos technical article database, record 104958. Reproduced with permission. The original is at www.sco.com/ta/104958, which is reachable but blocked from search engines. Xinuos marks this article against a retired product line. That refers to the product’s lifecycle, not to whether the advice still works — plenty of it still applies to running systems.

Next step

Need this fixed rather than explained?

Tell us the release, what the system runs and what it is doing. We will reply by email with what we would do next.

  • You deal with the people who do the work
  • No obligation, and no upgrade required before we will help
  • We tell you plainly if something is not worth doing

Send an enquiry

We reply by email. If a server is down, say so in the first line. You can also write to help@scoexpert.com.