Technical article 118472

The installation of SCO OpenServer 5.0.6 on a Toshiba Satellite 3000-X4 notebook, hangs during the 5.0.6 hardware initialization stage "hwconfig".

OpenServer 5.0.6

Written · Last revised

Problem

I have a Toshiba Satellite 3000-X4 with the following hardware configurations:

* Toshiba Satellite 3000-X4 * Intel Celeron 933 MHz / 128 KB 2nd level cache * 128 MB Memory PC 133 SDRAM * 15 GB IDE disk Toshiba MK1517GAP * Intel 830MG Video chip 16 MB * IDE DVD-ROM

I have problem to install Openserver 5.0.6.  When I boot via Openserver 5.0.6 Install
CD-1, the installation hangs the laptop when trying to load the "eiad"
driver:
eiadinit......

Cause

This is caused by the incorrect probing of a device (the Texas Instruments PCI 1410 controller) in the notebook.

Openserver 5.0.6 thinks that it has found some sort of SCSI controller that it
cannot correctly identify.  It then tries to load every scsi driver from CD,
to see which one works with this unknown SCSI controller.  In this
case, the "eiad", Adaptec 1740 EISA in enhanced mode, is the first
scsi driver to be loaded, which then causes the laptop to hang.

Solution

INSTALLATION:

When you boot with the Openserver 5.0.6 install CD, you will notice that it will hang at the initializing (the system hangs also. Only a cold restart is possible) eiadinit.....

Because of the suspected "Texas Instruments PCI 1410 controller", the OS tries to load every SCSI driver that could match.

The following drivers will cause the system to hang in the fashion mentioned above:

driver        init()        device
name          function      name
--------------------------------------------------------------------
          dptr          dptrinit      DPT SCSI & RAID Host Adapters
          eiad          eiadinit      Adaptec 174x (in Enhanced mode)
          mdac          mdacinit      Mylex Disk Array Controller
          wdex          wdexinit      Future Domain (formerly Western
                                      Digital) 7000EX
          eha           ehainit       Unknown device

Therefore, in order to install Openserver 5.0.6 on this laptop, you need to add this boot string:

defbootstr disable=eiad,dptr,mdac,eha,wdex
The install will continue successfully.

It has been reported that this syntax does not always work and you may need to add this boot string :

defbootstr disable=eiad disable=dptr disable=mdac disable=eha disable=wdex

From the Xinuos technical article database, record 118472. Reproduced with permission. The original is at www.sco.com/ta/118472, which is reachable but blocked from search engines.

Next step

Need this fixed rather than explained?

Tell us the release, what the system runs and what it is doing. We will reply by email with what we would do next.

  • You deal with the people who do the work
  • No obligation, and no upgrade required before we will help
  • We tell you plainly if something is not worth doing

Send an enquiry

We reply by email. If a server is down, say so in the first line. You can also write to help@scoexpert.com.