Technical article 114643

The kernel relink during installation of rs506a fails with the error, Undefined symbol "microdata"...

OpenServer 5.0.6

Written · Last revised

Problem

During the kernel relink phase of the installation of rs506a, I get one of the following errors:

Undefined symbol "microdata" first referenced in file
/var/opt/K/SCO/link/1.1.1Ga/etc/conf/pack.d/smpw/Driver.o
Undefined symbol "microdata" first referenced in file
/var/opt/K/SCO/link/1.1.1Ga/etc/conf/pack.d/spwr/Driver.o

Cause

The "microdata" symbol was removed from the clock driver in rs506a.

This symbol was used by older versions of the spwr and smpw drivers, and these drivers were also updated to not use this symbol in rs506a.

However, the installation of rs506a fails to move these new drivers into the link kit if you were already using them.

The new drivers are loaded onto the system so that new network card configurations using these drivers will result in the updated drivers being loaded into the kernel.

You might also see these errors if you try to install older versions of these drivers onto a system with rs506a.

Solution

This has been reported to SCO Engineering.

To update the system,

- Use the SCOadmin Network Configuration Manager (netconfig) to examine and write down the current configuration for the network card.

- Remove the card by highlighting it and selecting Hardware -> Remove network device.

- Re-add the network card using the configuration parameters you
  wrote down.  Hardware -> Add new LAN adapter.
- Reboot the system

If you are getting this error after adding older versions of these drivers onto rs506a, simply remove the older drivers and use the drivers provided in rs506a, and update the system as above.

See also

ta113341, " What problems are fixed in Release Supplement 506a for SCO OpenServer Release 5.0.6?"

From the Xinuos technical article database, record 114643. Reproduced with permission. The original is at www.sco.com/ta/114643, which is reachable but blocked from search engines.

Next step

Need this fixed rather than explained?

Tell us the release, what the system runs and what it is doing. We will reply by email with what we would do next.

  • You deal with the people who do the work
  • No obligation, and no upgrade required before we will help
  • We tell you plainly if something is not worth doing

Send an enquiry

We reply by email. If a server is down, say so in the first line. You can also write to help@scoexpert.com.