Problem
The setcomp table in the tape(C) manual page which shows the valid compression and decompression settings of a tape drive is incorrect.
Argument numbers 1 and 2 are incorrect, while 0 and 3 are correct.
The table currently reads:------------------------------------------
Value of arg Compression Decompression
------------------------------------------
0 disabled disabled
1 disabled enabled
2 enabled disabled
3 enabled enabled Solution
The setcomp table should read:------------------------------------------
Value of arg Compression Decompression
------------------------------------------
0 disabled disabled
1 enabled disabled
2 disabled enabled
3 enabled enabledThe tape(C) getcomp command may be used to return the current compression and decompression settings of a tape drive.
The tape(C) manual page will be corrected in a future release of the product.
See also
tape(C)