Problem
There are many dlvr_audit(ADM) processes on the system reported by
ps(C). The number of these seem to slowly increase over time,
adversely affecting system performance. Cause
There are two possible causes of this problem:
1. Auditing has been enabled on the system, but the audit daemon, auditd(ADM), has died unexpectedly.
2. Auditing is not enabled, but an application that uses message queues has been run and/or is running on the system. This has created a queue with the same message id as specified in the audit sub-system configuration file:
/tcb/files/audit/audit_dmninfoIn both cases, earlier invocations of dlvr_audit(ADM) (which is run by many system utilities including passwd(C), lp(C) and cron(C)) put messages in the message queue with the id specified in /tcb/files/audit/audit_dmninfo.
This queue is now full, and any further invocation of dlvr_audit(ADM) will block waiting for the queue to drain. The queue never drains, causing the slowly increasing number of dlvr_audit(ADM) processes on the system.
Solution
Additional dlvr_audit(ADM) processes can be prevented from accumulating in the system by removing:
/tcb/files/audit/audit_dmninfokill(C) can then be used to remove the unwanted dlvr_audit(ADM) processes, or the system can be rebooted to clear the process table.
In the case described under number 1 above, rebooting the system should re-start the audit daemon. If auditd(ADM) continues to die unexpectedly, contact your SCO support supplier for further assistance.
See also
ta100819, "Unexpected messages on message queue 50 when passwd(C) or lp(C) are run."
The manual pages for dlvr_audit(ADM), auditd(ADM), ps(C) and kill(C).