Problem
I have installed the SCO Gateway for NetWare using Software
Manager. It shows as fully installed. Running a "System
Verify" finds no errors with the installation. When I type
"nuc start" from the command line, I receive the following
errors:"Management Portal open failure" "Can not find Gateway for NetWare status."
Using "track on" at the console I can see SAPS coming from Netware and NVT servers, but slist returns:
"Cannot find fileserver to query" Cause
The system was installed without selecting to install the Gateway for NetWare, or the system was installed without selecting to configure a Network Interface. If the Gateway for Netware is installed in either of these scenarios, the Software Manager will not automatically add the Gateway for NetWare component to the IPX/SPX chain. This chain creates the links that the kernel uses to communicate from the Netware client functions (such as slist) to the transport layer (IPX). Without these 'portals' the communication will not function.
Solution
Run 'Network Configuration Manager (netconfig)' and add the 'SCO Gateway for Netware' protocol to the IPX/SPX component. Relink the kernel and reboot. You should then be able to run the nuc utilities such as slist, nwlogin, etc., successfully. For a more detailed explanation of how to add the Gateway component, see the 'Administering SCO Gateway for Netware' section of the SCO OpenServer Documentation.