Technical article 109322

Under OpenServer 5.0.4, after rs504c is installed, my Pentium II processor appears as "type=unknown" in hwconfig.

OpenServer 5.0.4

Written · Last revised

Problem

I have installed the Release Supplement 504C (rs504c) on SCO
OpenServer Release 5.0.4.  Now, the hardware configuration screen
reports that my Pentium II CPU is "type=unknown". I am concerned
that my CPU is not being detected and used properly.

To make sure that your CPU is being correctly utilized, run the program 'hw' with this syntax:

# hw -r cpu

The hw utility scans the hardware present and reports it accurately. It will provide information similar to this:

Report about cpu for host.domain.com on Wed Apr 29 15:35:37 1998

There is one CPU on this system.

The CPU performs like a 234Mhz Intel Pentium II

Model Specific registers
TSC:  0x0000a7d14b65019b
APICBASE:  0x00000000fee00100
BootStrap Processor:  Yes
APIC Global Enable:  Disabled
EBL_CR_POWERON:  0x00000000c5400000
Data bus error policy:  Parity
Clock Frequency Ratio:  5
MISC_ADDR33:  0x0000000000000000
Instruction Streaming Buffers: Enabled

Solution

This problem is resolved in SCO OpenServer 5.0.5.

See also

The man pages for HW, hwconfig(C)

From the Xinuos technical article database, record 109322. Reproduced with permission. The original is at www.sco.com/ta/109322, which is reachable but blocked from search engines. Xinuos marks this article against a retired product line. That refers to the product’s lifecycle, not to whether the advice still works — plenty of it still applies to running systems.

Next step

Need this fixed rather than explained?

Tell us the release, what the system runs and what it is doing. We will reply by email with what we would do next.

  • You deal with the people who do the work
  • No obligation, and no upgrade required before we will help
  • We tell you plainly if something is not worth doing

Send an enquiry

We reply by email. If a server is down, say so in the first line. You can also write to help@scoexpert.com.