Problem
I used either "scoadmin network configuration manager" ("netconfig"),
"mkdev ptty", or "configure" to update the number of pseudo ttys
that the system has available. However, when I bring up netconfig
again to view or modify the protocol configuration, the number of
pseudo ttys is listed as 32. No matter how many pseudo ttys I
specify, netconfig always lists 32 as the number being configured. Cause
Netconfig fails to read the current configuration value of the NSPTTY parameter as specified in the /etc/conf/cf.d/stune or mtune file, but instead always reports 32 as the configuration.
Solution
Using "configure" to increase the number of pseudo ttys is not
recommended since configure only updates the kernel tunable
parameter; it does not add the necessary device nodes. If
"configure" was used to adjust NSPTTY, it is recommended
that NSPTTY be reset to the original value, and then adjusted
as desired using "mkdev ptty" as detailed below.If either scoadmin/netconfig or "mkdev ptty" was used to adjust
the number of pseudo ttys, netconfig will still report that the
number of pseudo ttys configured is 32, however the update
performed was effective. The stune file was updated and entries
were added to the spt and mpt files under the /etc/conf/node.d
directory.To confirm the actual number of pseudo ttys configured, type this command at the shell prompt:
mkdev pttyand select the option to display the number of pseudo ttys
configured. If you wish to change the existing value, using
"mkdev ptty" is the recommended method.This problem has been reported to SCO Engineering.
See also
netconfig(ADM), mkdev(ADM), configure(ADM), mtune(F), stune(F),
scohelp(XC)Documents/scohelp: SCO Performance Guide, Appendix B, section "TTY and console configuration"