Problem
I'm trying to install SCO OpenServer Enterprise System Release
5.0.4. I have two licenses: the first contains an "o" flag in
the license data field; the second contains an "r" flag in the
license data field. Here are examples of the two licenses, with
typical descriptions as contained on the COLA (Certificate of
License and Authenticity):SCO OpenServer Host System 16-user License Upgrade from 16-user or greater UNIX:
License Number: 2ST000011
License Code : oicurmtu
License Data : k;o3.0;u16;m9fj1532SCO OpenServer Enterprise System Upgrade from Host System:
License Number: 2ST000022
License Code : oucimaok
License Data : k;r130/5.0;m8jj50yrSimilar licenses exist that should allow you to upgrade from SCO Open Desktop 3.0 to SCO OpenServer Desktop System 5.0.4, and then to upgrade to SCO OpenServer Enterprise System 5.0.4 using a license with "r128/5.0" in the license data field.
I am experiencing a problem that matches one of the scenarios
described below. ISL stands for "initial system load", that is,
an installation from boot floppy and CD-ROM; "Layered" stands for
the layered installation of Enterprise on an already installed
Host or Desktop System. In these latter cases, the ISL using
the "o" license has already proceeded successfully.TYPE OF INSTALLATION PRODUCT I WISH TO INSTALL RESULT/PROBLEM
-------------------- ------------------------- --------------1) Fresh, ISL Enterprise 5.0.4 or 5.0.2 Use of "r" license during
ISL results in error
message "Invalid license
data flag: 'r'"2) In-Place Upgrade, Enterprise 5.0.4 Same as above
ISL3) Layered Enterprise 5.0.4 Use of "o" license during
ISL of Desktop or Host
was successful; however,
after completing the
installation and observing
what components are
installed, I notice red
"X"s through the
Fasttrack Server and
FastStart Admin components.
These components are not
present on the system. Solution
For scenario 1) above:If you are trying to install SCO OpenServer Enterprise System
Release 5.0.2 or 5.0.4, you are not using the correct license to
achieve this. Use the "o" license instead, during ISL, to install
the OpenServer Host (or Desktop) product; then perform a layered
install of OpenServer Enterprise using the "r" license.For scenario 2) above:The "r" flag in the upgrade license will prevent a successful
in-place upgrade. Contact SCO Support to obtain a replacement
license. Note: The Internet FastStart Administration package,
including the Internet Manager, cannot be installed. See TA105664
for details.For scenario 3) above:In these cases, ISL was either done properly the first time, or
corrected using the solution for scenario 1). However, incomplete
installation of the Internet FastStart software components will
result. In addition, subsequent attempts to perform layered
installation of these components are likely to fail. If you wish
to install these components, please go to:http://www.sco.com/support/landr/license_lost.htmlPlease fill out the "SCO License Replacement Request Form"
NOTE: When performing the layered installation of OpenServer Enterprise,
make sure NOT to choose the Enterprise selection within the
"SCO OpenServer Software" entry in the list of software products.
These same considerations apply to SCO OpenServer Enterprise System
Releases 5.0.0, 5.0.2 and 5.0.4. See also
TA105609, "My license is rejected with the error 'Invalid license data flag: 'r'' on 5.0.4".
TA105664, "The Internet FastStart package did not install after an in-place upgrade to OpenServer Enterprise Release 5.0.4".