Technical article 100107

Using ARCserve with NCR SCSI controller returns sense code messages.

OpenServer 5.0.0OpenServer 5.0.2

Written · Last revised

Problem

An SCO OpenServer 5.0.0/5.0.2 system running on a Digital Celebris XL5133, using the onboard "NCR 53C810" SCSI controller, either with the slha or the older bhba SCSI driver, and a tape drive that is shown as supported for SCO ARCserve, returns this message:

sense key = 02, asc/ascq=3a 00 on ha0 id3 lun0

This message is displayed every five seconds if the tape is
removed from the drive.  Similar "sense key" messages will
also be displayed after completion of an ARCserve backup:

sense key = 05, asc/ascq=3a 00 on ha0 id3 lun0

and/or:

sense key = 06, asc/ascq=3a 00 on ha0 id3 lun0

and/or:

sense key = 08, asc/ascq=3a 00 on ha0 id3 lun0

The SCO ARCserve backup seems to be valid.  An ARCserve restore
of files or a full restore works fine from ARCserve.

Also if ARCserve is not started or is stopped and either SCO Backup Manager or tar, cpio or dd is used to access the tape device, the following message may be returned:

sense key = 02, asc/ascq=3a 00 on ha0 id3 lun0

It will be displayed every time the tape device is accessed.

Note: In the above "sense key" messages the ha, id and lun may be different from those shown.

Cause

These messages are returned because older versions of the bhba/slha drivers check for timeouts that are occurring due to queries to a tape device. SCO ARCserve queries tape devices every five seconds through its SCSI pass-through driver.

Solution

A newer version of the slha driver (4.02.00) that ignores timeout queries is available from the Symbios Logic Web site (www.symbios.com) or anon ftp site (ftp.symbios.com).

Note: Sense code data:
0x02 Drive not ready
0x05 Illegal Request
0x06 Unit Attention - Cartridge changed or drive has been reset.
0x08 Blank Check  - End of Data
NOTE:     The SCO Open Server 5.0.4 slha driver has been modified to ignore
          the timeouts and not return the "sense code" messages.

See also

man slha(HW), tar(C), cpio(C), dd(C)

From the Xinuos technical article database, record 100107. Reproduced with permission. The original is at www.sco.com/ta/100107, which is reachable but blocked from search engines. Xinuos marks this article against a retired product line. That refers to the product’s lifecycle, not to whether the advice still works — plenty of it still applies to running systems.

Next step

Need this fixed rather than explained?

Tell us the release, what the system runs and what it is doing. We will reply by email with what we would do next.

  • You deal with the people who do the work
  • No obligation, and no upgrade required before we will help
  • We tell you plainly if something is not worth doing

Send an enquiry

We reply by email. If a server is down, say so in the first line. You can also write to help@scoexpert.com.