Problem
The following error is in my /usr/adm/syslog file:
Sep 13 14:52:58 machine pppd[9562]: Link id(339):Received frame abort with bad fcs=0x8ef0 msglen=0x23
where "machine" is the machine name, pppd[xxxx] is the process id of the pppd process, and fcs= and msglen= are hex numbers. There may be any number of these errors, from one or two up to several hundred.
Cause
This can be caused by a number of conditions. The low-level data
units in a TCP/IP connection are called "frames", and the error
indicates a "frame check sequence" problem. Frames contain
headers that describe the source and destination; most frames
also contain trailer information used to detect transmission
errors.The sender of a frame performs a calculation and puts the result
into the trailer as the "frame check sequence". The receiver
performs the same calculation and compares the result with the
data in the trailer. If the values agree then it is likely that
the data arrived intact.When you get an error in the fcs, therefore, it means a bad frame has been received and detected as an error.
Solution
A small number of these errors -- less than 10 or 20, may be normal and unavoidable. If you have large numbers of these errors, or if the errors seem to be causing problems with the PPP connection (pauses in data transfers, jerky connections, timeouts, etc.), there are some things you should check.
In general, these errors are caused by problems on the serial
line itself, and not the overlying TCP/IP protocol. SCO Support
has seen the following as influencing factors:o bad phone line (noisy line) o old UART (something previous to a 16550 UART) o bad cabling o high speed modem misconfigured (see other articles in this database for tips on configuring modems properly) o connection speed too high to ensure data integrity o incorrect dialer selected for the modem o problems with flow control or data compression
In general, simplify the PPP link as much as possible and then
make changes from there. For instance, start at 9600 baud, make
sure the correct gettydefs entry is used in /etc/inittab, disable
hardware compression, use rtscts (hardware) flow control, try
different dialers, use the minimum number of fields in your ppphosts
file, switch modem and/or cabling, move the modem to another serial
port, make sure the ACCM and MRU values for the client and server
match, and so on.If none of these suggestions work, contact your support provider for other options.