Problem
What is SLS OSS638A, the rarpd Supplement for OpenServer 5?
Solution
SLS OSS638A, the rarpd Supplement for OpenServer 5, addresses the following problems:
1. If the interfaces to attach to are not all at the beginning of the interface list, then rarpd fails to attach to all of them.
2. In some circumstances, an error message was seen when rarpd was trying to attach to aliases and failed because it is only allowed to attach to each interface once.
See the attached cover letter for more information, including installation instructions.
Dear SCO Customer,Support Level Supplement (SLS) OSS638A, the rarpd Supplement for OpenServer 5, corrects problems with rarpd (the Reverse Address Resolution Protocol daemon).
SLS OSS638A corrects these problems:1. If the interfaces to attach to are not all at the beginning of the interface list, then rarpd fails to attach to all of them. The Compaq cnet driver is an example of a NIC driver that ends up listed after the atl0 interface.
2. In some circumstances, an error message was seen when rarpd was trying to attach to aliases and failed because it is only allowed to attach to each interface once.
SLS OSS638A contains these files:/etc/rarpdSoftware Notes and Recommendations
----------------------------------SLS OSS638A should only be installed on:
SCO OpenServer Release 5.0.6
SCO OpenServer Release 5.0.5Installation Instructions
-------------------------1. Download the OSS638A media image file (https://ftp.scoexpert.com/SLS/oss638a), place the file in the /tmp directory, and rename the file by typing the command:
mv /tmp/oss638a /tmp/VOL.000.0002. Run the Software Manager with the command:
# scoadmin softwareor double-click on the Software Manager icon in the desktop.
3. Pull down the "Software" menu and select "Install New".
4. When prompted for the host from which to install, choose the local machine and then "Continue".
5. In the "Select Media" menu, pull down the "Media Device" menu. Select
"Media Images", then choose "Continue".6. When prompted for the "Image Directory", enter "/tmp" (or the directory where you placed the VOL file in step 1) and choose "OK".
7. When prompted to select software to install, make sure that
the "OSS638A" entry is highlighted. Choose "Install".8. Installation of SLS OSS638A is now complete. To exit the
Software Manager, select "Exit" from the "Host" menu.Removal Instructions
--------------------Note: Patches must be rolled back in the reverse order in which they
were installed on a per-component basis. That is, if SLS OSS638A
is not the most recent patch applied to the connectivity component of
the product, you will have to roll back all patches applied after
SLS OSS638A, prior to rollback of SLS OSS638A.To remove SLS OSS638A from SCO OpenServer 5.0.5 and 5.0.6, take these steps:
1. Log in as root.2. Execute the command:# scoadmin softwareor double-click on the Software Manager icon in the desktop.
3. Highlight "OSS638A: rarpd Supplement for OpenServer 5".
4. Pull down the "Software" menu and select "Remove Software".
5. Once the removal finishes, quit the Software Manager. Removal of
SLS OSS638A is now complete.If you have questions regarding this SLS, or the product on which it is installed, please contact your software supplier.