Problem
Buffer overflows have been found in the following 19 SCO OpenServer 5 utilities:
/usr/bin/accept /usr/bin/cancel /usr/mmdf/bin/deliver /usr/bin/disable /usr/bin/enable /usr/lib/libcurses.a /usr/bin/lp /usr/lib/lpadmin /usr/lib/lpfilter /usr/lib/lpforms /usr/lib/lpmove /usr/lib/lpshut /usr/bin/lpstat /usr/lib/lpusers /usr/bin/recon /usr/bin/reject /usr/bin/rmail /usr/lib/sendmail /usr/bin/tput
NOTE: the accept, reject, enable, and disable commands are symbolically linked to the same binary.
Running any of the above utilities with a very large argument
can result in a core dump. For example:/usr/lib/lpshut `perl -e 'print "A" x 10000'` Solution
Install SSE072C. This patch is applicable to all releases of OpenServer 5 up to, and including, 5.0.6.
This patch contains replacements for all binaries listed above.
This patch supersedes SSE072B. Removal of previous versions of this patch (SSE072B and SSE072) before installation of SSE072C is not necessary.However, there is no need to install SSE072C on a system which has RS506A installed _AND_ which already has either SSE072B or SSE072 installed.
A copy of SSE072C is available from the SCO Security website at URL:
[link no longer available]NOTE: The patched /usr/lib/sendmail furnished with SSE072C (and also
SSE072 and SSE072B) is only for the version that is installed
on a system which is using MMDF. If your system is using Sendmail,
the installed /usr/lib/sendmail should not be replaced by the
SSE072C version. The installation procedure below, however,
does not distinguish between the Sendmail and MMDF versions
of this binary, and simply replaces whatever binary is there.
To work around this problem, if you are actually using Sendmail,
then first copy the original /usr/lib/sendmail (or retrieve it
from /opt/K/SCO/sse/sse072c, if you have installed SSE072C)
and replace, with this copy, the SSE072C version of /usr/lib/sendmail
after you have installed the patch.NOTE: In previous versions of this patch, the replacement /usr/bin/tput
was not compatible with pre-5.0.6 releases of OpenServer 5--the error
"dynamic linker: tput: symbol not found: strlcpy" was obtained, and
the user would not be prompted for, and would not be able to set,
the TERM type for the session. Numerous other binaries furnished
with these previous versions can also exhibit similar problems.
Installation of SSE072C will fix these problems. There is no need
to remove a previously installed version before installing SSE072C.