Problem
Some non-SCO software (for example DECnet) requires the ability to dynamically set the MAC address of the network interface card (NIC). What network drivers on OpenServer Release 5 support this functionality?
Solution
Some SCO networking drivers support dynamically settable MAC
addresses. These drivers fall into two classes, namely MDI drivers
and LLI drivers, and are listed below.Note that special steps must be taken if there is a requirement to support TCP/IP networking on the target network interface card; see "TCP/IP Notes" below.
MDI DriversStarting with OpenServer Release 5.0.4, the following network drivers support dynamic MAC address selection:
wdn Western Digital WD8003/WD8013
pnt AMD PCNet-ISA/PCNet-ISA+/Novell NE2100Versions of the pnt and wdn drivers with this functionality are available for SCO OpenServer Releases 5.0.0 and 5.0.2 and for SCO Internet FastStart Release 1.0.0 and 1.1.0 by installing SLS OSS439A.
LLI DriversOpenServer can support older LLI drivers with some limitations in
functionality (see "Backward compatibility with LLI drivers" in the
"Configuring Network Connections" chapter of the SCO OpenServer
Handbook). The following LLI drivers available on SCO OpenServer
Release 5 support dynamic MAC address selection:btok IBM Token-Ring Network 16/4 Server/A MCA
e3A 3COM 3c501 EtherLink
e3D 3COM 3c507 EtherLink 16 Series
hpe HP 27248 EISA LAN Adapter/32
hpi HP 272XX PC LAN Adapter Series
i3B Racal InterLan ES3210 EISA
i6E Racal InterLan NI6510 EtherBlaster ISA
nat Novell/National Semiconductor NE2000
ne Novell/National Semiconductor NE3200 Bus Master
wdn Western Digital WD8003/WD8013These drivers are available on the Advanced Hardware Supplement Release 3.4 (AHS 3.4).
Note, however, that these older LLI drivers have not been updated to
support the dynamic streams buffer allocation mechanism introduced in
OpenServer Release 5. These drivers assume that a streams buffer is
located in a block of physically contiguous memory which can be
processed in a single DMA transfer request, an assumption that is no
longer true with Release 5 of OpenServer. A workaround, which will
force all streams buffers to reside in physically contiguous memory,
is to set the STRMAXBLK kernel parameter to 4096 using the
Hardware/Kernel Manager followed by relinking the kernel. This
workaround is satisfactory for running TCP/IP and DECnet, but it may
have an adverse effect on any applications that benefit from or
require larger streams buffer sizes.TCP/IP NotesIf there is a requirement to support TCP/IP networking on the target
network interface card, the new MAC address must be set on the card
before TCP/IP is started for the first time after booting. However,
on SCO OpenServer Release 5, TCP/IP starts up early in the boot
sequence, well in advance of the machine entering multiuser mode and
before the system setup scripts are executed.To work around this, use the boot option ksl.disable (add the command
"ksl.disable" to the DEFBOOTSTR line in /etc/default/boot). This
allows the system to come up into single-user mode without starting
TCP/IP. At this time, the MAC address may be changed by the user's
application software. TCP/IP will start up automatically when
entering multiuser mode and will use the new MAC address assigned to
the card.