Technical article 109788

3Com 592 and 3Com 597 EISA network cards do not work in SCO OpenServer 5.0.5, 5.0.6.

OpenServer 5.0.5OpenServer 5.0.6

Written · Last revised

Problem

I have installed SCO OpenServer 5.0.5 or 5.0.6 and configured my
network.  However, the networking does not work and I get a warning
message on bootup during the hardware display:

WARNING: e3G : cannot install intr vecno=65535, type=4, IPL=5 Bad interrupt vector 65535

Another similar error message is the following:

idistributed: <driver> bad interrupt vector (65535)

Solution

The e3G driver shipped in SCO OpenServer 5.0.5 does not work
properly.  It can be replaced with the driver from SCO OpenServer
Release 5.0.4.

Note: Do NOT use the e3G driver from SCO OpenServer 5.0.4C, which is also faulty.

Take these steps:
1. Obtain a copy of the OpenServer 5.0.4 e3G driver.  This
is available by anonymous ftp from ftp.sco.com in the directory:
https://ftp.scoexpert.com/drivers/OSR504/network/e3G
Two files will be shown:
VOL.000.000      Size  53248 bytes
e3G.readme       Size   2451 bytes

Transfer the volume image to the target system and place in /tmp/vol, for example.

2. Run "netconfig" and select the network card. Then choose
"Hardware" from the header choices, followed by "Remove network
device".  Once the network adapter software has been removed and
the kernel relinked, restart the system.
3. Run "custom" (the Software Manager) and remove the 3Com59x (e3G)
driver.  This may be done as follows:

- Select the operating system, for example, SCO OpenServer Enterprise System.

- Click 'View -> Expand' on the menu at the top of the window.

- Select 'Connectivity' and then 'View -> Expand'.

- Double-click on 'Network Drivers'.

- Select "3Com 3C59X Etherlink III" and then 'Software -> Remove Software'.

- Confirm removal when prompted.
4. Run "custom" again and select 'Install New'.  Install from the
system using 'Media Images'.  Give the directory name where the
volume image in item 1 has been stored, for example, /tmp/vol. When
complete, the item "3Com 3C59X Etherlink Series III (ver 5.0.4d)"
should appear in the list of installed software.
5. Run "netconfig" to add the network card. Select "Hardware",
then "Add new LAN adapter".  Configure the network card.  The
kernel will be relinked.  Restart the system.

The network should now be operational, assuming the network is properly configured.

See also

TA105872, "Installation of Release Supplement 504C causes my network card to give an error or fail completely."

From the Xinuos technical article database, record 109788. Reproduced with permission. The original is at www.sco.com/ta/109788, which is reachable but blocked from search engines.

Next step

Need this fixed rather than explained?

Tell us the release, what the system runs and what it is doing. We will reply by email with what we would do next.

  • You deal with the people who do the work
  • No obligation, and no upgrade required before we will help
  • We tell you plainly if something is not worth doing

Send an enquiry

We reply by email. If a server is down, say so in the first line. You can also write to help@scoexpert.com.